← All writing

Choosing what my AI session loads

An archived cleanup request led me to look more carefully at plugins, skill descriptions and session context.

One of my earliest archived notes in this review starts with a fairly practical question: why was my setup asking me to authenticate 15 MCP (Model Context Protocol) servers when I didn’t think I was using them?

That archive entry is dated October 9. It’s a starting point for this retrospective, with some limits: it was imported from an older conversation, so the date doesn’t prove exactly when every change happened. It also doesn’t mark my first use of AI.

I was trying to reduce unnecessary context. My initial request grouped MCP servers together as a token expense, but the investigation needed a more careful distinction. A plugin can advertise capabilities to the assistant. A skill can contribute a description before the assistant reads its full instructions. Tool definitions can also load only when needed. Counting installed integrations doesn’t tell me how much text a particular session receives.

I approved removing unused plugin groups. The assistant reported disabling six groups, although a restart was still needed to check the effect in a fresh session. That’s a narrower result than saying the cleanup made everything faster or cheaper. I didn’t have a measured before-and-after comparison.

At the same time, I wanted access to useful development workflows, including Matt Pocock’s skills. Removing everything would have worked against that goal. I asked for a smaller way to direct the assistant toward the relevant workflow without presenting a large collection of instructions on every task.

The proposed setup used a small project-local selection of skills and a short router. There was a rough token estimate in the conversation, but I wouldn’t use it as a savings figure. It described the intended setup, without measuring a completed session against the previous one.

Looking back, the useful question was which instructions the assistant would receive when I asked it to do something. I wanted to retain the workflows I used and stop carrying unrelated ones by default. Checking that required opening a new session and observing what loaded. Editing the settings was only the first part of that check.

Written by . Follow via RSS ↗